ASSEMBLY:
WHEEL
FRONT HANDLE
CHASSIS
REAR HANDLE
1. Attach Wheels
Tip body/chassis on its side. Snap wheel onto axle, with flat side of wheel against chassis. Repeat for remaining 3 wheels.
BODY
CARD-
BOARD
INSERT
2. Assemble Handles
To snap front and rear handles together: Place rear handle upside down on flat surface. Holding front handle with back facing rear handle and perpendicular to rear handle, snap posts on front handle into holes in rear handle.
FRONT
HANDLE
SLOT
3.Attach Handle Assembly to Body
Lift body and remove cardboard insert.
Turn body/chassis on its side. Insert front handle through slot in body.
RIDGES
AXLE
SCREWS | HANDLE | |
RETAINER | ||
|
Fit axle on rear handle into ridges in underside of body. Place handle retainer over axle (retainer fits only one way). Using the 4 plain #6 screws and Phillips/cross head screwdriver, attach retainer to body.
NOTE: If body is locked closed, see back panel for conversion instructions.
