TO ASSEMBLE
1.Remove table from packaging.
2.To insure proper,
2.Each storage compartment’s lid incorporates an activity: one lid is a shape sorter, the other one is a drop slot.
|
| NOTE: Check to |
|
| insure tabs are fully |
|
| inserted in slots. |
3. Snap top two peg | 4. Set the two lids into | 5. Drop motorized gear |
plates onto the top, | the recesses over | into center, button side up, |
in front and in back. | the storage buckets. | after installing batteries. |
3.25 CLIPO™ pieces included to create a variety of designs. Table surface acts as a platform to build CLIPO™ creations.
4.Works with all CLIPO™ products! Each sold separately. Add them on for more CLIPO™ fun.
NOTE: When storing toy, turn the ON/OFF switch to OFF to prevent accidental activation. If batteries begin to lose power, gears will turn at a slower rate and it will be less powerful. For best results, replace batteries when this starts to happen.
FCC STATEMENT
Check to insure tabs are in slots.
TO PLAY
NOTE: To remove motorized |
gear, use CLIPO™ piece and lift up. |
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions,
The CLIPO™ CREATIVITY TABLE toy features (2) spinning turntables.
Center is stationary when assembled into table for stacking fun and display platforms!
1. Slide ON/OFF switch located on the
bottom of the motorized gear unit to “ON” position.
· Press the button on top of the motorized gear to run the motor.
This will start the center gear and turn the two outside turntables.
The spinning continues for approximately10 seconds, then stops. Push the button again to
spinning action. | Continued on next page |
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful inter- ference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and the receiver.
-Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
| 7HRHS |
Product and colors may vary. | BNL |
© 2008 Hasbro. All Rights Reserved. | |
TM & ® denote U.S. Trademarks. | |
09949 PN 6769550000 | Questions? Call |
