
TO INSERT BATTERIES
Using Phillips/cross head screwdriver, loosen screw in battery compartment cover (screw stays attached to cover). Remove cover. Insert 3 x 1.5V "AA"/LR6 alkaline batteries. Replace cover and tighten screw.
CAUTION: TO AVOID BATTERY LEAKAGE
1.Be sure to insert the batteries correctly and always follow the toy and battery manufacturers' instructions;
2.Do not mix old batteries and new batteries or alkaline, standard
3.Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1.Always follow the instructions carefully. Use only batteries specified and be sure to insert item correctly by matching the + and – polarity markings.
2.Do not mix old batteries and new batteries or standard
3.Remove exhausted or dead batteries from the product.
4.Remove batteries if product is not to be played with for a long time.
5.Do not short circuit the supply terminals.
6.Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment. Reset (switching off and back on again or removing and
7.RECHARGEABLE BATTERIES:Do not mix these with any other types of battery. Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
Your NERF TECH TARGET game can be played while hung on a wall or propped against a wall or door.
TO HANG
• To hang your NERF TECH TARGET game on the wall, mount 1 nail or screw (not included) onto the wall. Align and place the mounting hole on the back of the TECH TARGET onto nail or screw in the wall.
•To ensure an optimal target range, hang your NERF TECH TARGET approximately 12 ft. away from where you will be standing.
NOTE: Be careful when nailing and/or screwing into your wall because it may damage your wall.