Hasbro 60742 manual To Insert Batteries, To Assemble

TO INSERT BATTERIES

Open storage door in the mountain (A4) to locate the screw in the battery compartment door. Use a Phillips screwdriver (not included) to loosen screw (screw remains attached to door). Remove door and insert 2 x fresh 1.5V “AA” or R6 size batteries. Alkaline batteries recommended. Replace door and tighten screw.

CAUTION: TO AVOID BATTERY LEAKAGE

1.	Be sure to insert the batteries correctly and
	always follow the toy and battery manufacturers’
	instructions;
2.	Do not mix old and new batteries or alkaline,
	standard (carbon-zinc) or rechargeable
	(nickel-cadmium) batteries;
3.	Always remove weak or dead batteries from
	the product.

TO ASSEMBLE

	A3
A1	A4

A2

Prior to assembly, insert batteries	Snap mountain (A4) into	Next, set butterfly ride into
(see directions at left).	place.	place on top of mountain as
First, snap two base pieces (A1, A2) together,		shown. Hook wing clips onto
		antennas.
and press logo piece (A3) into place.

IMPORTANT: BATTERY INFORMATION Please retain this information for future reference. Batteries should be replaced by an adult.

CAUTION:

1.Always follow the instructions carefully. Use only batteries specified and be sure to insert them correctly by matching the + and – polarity markings.

2.Do not mix old batteries and new batteries, or standard (carbon- zinc) with alkaline batteries.

3.Remove exhausted or dead batteries from the product.

4.Remove batteries if product is not to be played with for a long time.

5.Do not short-circuit the supply terminals.

6.Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment. Reset (switching off and back on again or removing and reinserting batteries) if necessary.

7.RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.

C3

C2

C1

Place rainbow arch (C1) and waterfall (C2) into place as shown. Snap heart-shaped cutout (C3) over the heart-shaped button located on the top of mountain. Press canopy onto mountain.

Assemble souvenir stand by pressing both poles into cover as shown. Press sign onto cover, then press assembled stand onto platform.

Press tree pieces together, then press tree into place. Press drink stand and signs into place as shown.