x2 ALKALINE
1.5V AA/LR6 size BATTERIES NOT INCLUDED REQUIRED
Phillips/cross head screwdriver (not included) needed to insert batteries.
Bump & Go
AGES 3+
69132/69128 Asst.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference. Batteries should be replaced by an adult.
To install batteries:
1. Using a Phillips/cross head screwdriver (not included), unscrew battery cover.
2. Insert 2 fresh 1.5 V “AA” or LR6 batteries. See diagram for polarity.
3. Replace battery cover and tighten screw.
Questions? Call:
Not suitable for children under 3 years because of
* | ® | small parts — choking hazard. |
| ||
|
|
CAUTION: TO AVOID BATTERY LEAKAGE
1.Be sure to insert the batteries correctly and always follow the toy and battery manufacturers’ instructions;
2.Do not mix old and new batteries or alkaline, standard
3.Always remove weak or dead batteries from the product.
CAUTION:
1.Always follow the instructions carefully. Use only batteries specified and be sure to insert item correctly by matching the + and – polarity markings.
2.Do not mix old batteries and new batteries or standard
3.Remove exhausted or dead batteries from the product.
4.Remove batteries if product is not to be played with for a long time.
5.Do not short circuit the supply terminals.
6.Should this product cause, or be affected by, local electrical interference, move
it away from other electrical equipment. Reset (switching off and back on again or removing and
7.RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
Product and colors may vary.
®* and/or TM* and © 2006 Hasbro. All Rights Reserved. TM & ® denote U.S. Trademarks.
