Always!

Read all instructions before installing any Havis-Shields Equipment Corp products. Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes! Use hardware provided with install kit

For product support, visit the Install Instructions Section of our website at http://havis.com/Installation/Installation.html, email technicalsupport@havis.com or call 1-800-524-9900.

INSTALLATION:

1.Remove front passenger seat bolts. Loosen, but do not remove, the two rear passenger seat bolts.

2.Place base of the pole support assembly underneath of the seat base brackets.

3.Align the holes of the seat base, the pole support assembly, and the floor holes. Replace the front seat bolts. Firmly tighten all four seat bolts without over tightening.

4.Making sure the pole is level; drill a 3/8” hole through the floor pan at the end of brace. Hold the threaded under the floor plate underneath and through-bolt the base using the supplied screw.

Telescoping

pole assembly

Pole support

assembly

Under floor plate (Not shown)

C-TCB-5_INST_9-07

Page 2
Image 2
Havis-Shields C-TCB-5 installation instructions Always, Installation