SILVER BILLET TM TRUCK MOUNT BRACKET INSTALLATION
4” OFFSET FOR
INSTALLATION:
1.Determine location of pole assembly on vehicle. Mark vertical center line of pole on vehicle body.
2.Mark hole locations on body using
3.Drill required holes in body and install
4.Install lower bracket (10) using the supplied 5/16” cap screws (11).
5.Disassemble upper bracket assembly completely as illustrated in exploded view. Install receiver (6) using supplied
6.Install latch assembly (7) into receiver making sure square flange on latch is seated in square recess on receiver. Tighten set screw (5) snug (do not over tighten).
7.Install tongue (2) in receiver as shown in side view. Clamp latch to secure tongue.
8.Position pole assembly in lower bracket. Make sure tripod legs are closed and fully seated in bracket. Position pole against saddle of tongue with tripod carrying handle facing outward and attach cap (1) using four supplied socket head screws
(3). Tighten screws firmly
9.Release latch and check for proper operation and alignment by removing and reinstalling pole assembly into truck mount. Adjust as needed. If latch tension is overly loose or too tight, loosen set screw (12) at end of latch and rotate latch handle slightly to adjust tension. Turn clockwise to increase tension and counter clockwise to reduce tension. When proper tension is attained retighten set screw.