![](/images/backgrounds/99297/99297-3626x1.png)
MOWER MAINTENANCE
Cutterblade Assembly
Assemble the cutterblade with the turned up edges facing towards the engine. Secure the cutterblade using the bolt, spring washer, and distance piece and tighten to a torque of 54Nm.
CS094
Cutterblade Sharpening
30° | A slightly worn cutterblade may be |
| must be sharpened equally to ensure balance. Sharpen the cutterblade |
| every 25 mowing hours or more frequently if conditions require. |
| Remove the cutterblade from the mower and clean using a brush and |
| water. Inspect the cutterblade for signs of damage.Sharpen both cut- |
| ting edges with a flat file to restore performance. |
Ensure that the cutterblade is balanced. Use a screw driver with a round shaft to support the cutterblade through its centre hole. Hold the cutterblade horizontal and then release. A balanced cutterblade will remain horizontal.
If the cutterblade is not balanced the heavy end will rotate downwards.
Sharpen the heavy end until the cutterblade is correctly balanced.
1.26