1.13

ASSEMBLY INSTRUCTIONS

1.13

ASSEMBLING THE MOWER FOR THE FIRST TIME

Unpack the mower: Remove the mower from the packaging and take great care to ensure that the control cables between the engine and the upper handlebar are not damaged in the process. Check that the loose items have been supplied correctly. Refer to the delivery checklist opposite. If any items are missing, contact your local authorised Hayter Dealer.

DELIVERY CHECKLIST

DescriptionQuantity

Owner’s Handbook

1

Warranty Reg. Card

1

Assemble the lower handlebar: Carefully unfold the lower handlebar into position behind the rear of the mower. Align with the base of the handlebar and lock in position using the lower securing knobs.

ST017

Assemble the upper handlebar: Carefully unfold the upper handlebar into position whilst taking great care to ensure that the control cables remain undamaged, untwisted and free of kinks.

Align with the lower handlebar and ensure that the rope guide is correctly orientated. Tighten the upper securing knobs .

Operate the engine stop lever towards the handlebar and very slowly pull the engine start-grip away from the engine until there is sufficient slack in the rope to enable it to be threaded into the rope guide. Gently release the start-grip until it rests against the rope-guide.

Align the control cables neatly along each leg of the han- dlebar and ensure that they are located in the plastic cable holders. Use a screwdriver to clamp the cable holders in position.

3

1

2

4

5

 

 

 

 

6

 

8

 

 

7

ST001

1.Coach bolt M8

2.Rope guide

3.Engine start grip

4.Upper handlebar

5.Lower handlebar

6.Washer M8

7.Knob

401001EB100398A