Hayter Mowers 410G, 412G, 413G manual Battery Charging Code 412 only, Refer, Mower Maintenance

Models: 410G 413G 412G

1 20
Download 20 pages 27.98 Kb
Page 14
Image 14
Battery Charging (Code 412 only)

MOWER MAINTENANCE

Battery Charging (Code 412 only) (Refer fig.39)

-PREVENT ACCIDENTS: ALWAYS charge the battery in a well ventilated area.

-NEVER charge the battery near naked flames or direct heat.

-ALWAYS switch off the mains electricity supply before disconnecting the charger from the battery.

-ALWAYS use the battery charger supplied with the mower.

-Battery charging should not be necessary during normal use. The engine operation will automatically charge the battery. If the mower is stored for a long period recharging the battery may be necessary to permit electric starting.

-To recharge the battery: Disconnect the battery lead from the mower lead and then connect the battery lead to the charger.

-Connect the charger plug to the mains electricity supply and switch on to charge the battery for a fourteen hour period. (Refer fig.38)

-Disconnect the battery lead from the charger and then

connect the battery lead to the mower lead.

IMPORTANT - PREVENT DAMAGE: NEVER connect the battery charger to the engine lead as this will cause the charger to be permanently damaged. Chargers damaged in this manner will not be replaced under warranty.

CAUTION - PREVENT ENVIRONMENTAL DAMAGE. (Refer fig.39)

The battery and charger have a separate collection mark.

This indicates that for disposal of the battery and battery charger they must be taken to an authorised disposal site. They must not be disposed of with general waste.

EU Directive 2002/96/EC classifies this product as an electrical or electronic equipment.

(a)These products should not be disposed of as unsorted municipal waste.

(Refer fig.39)

(b)They should be taken to a designated collection point or recycling centre and handled according to national laws in the area.

(c)The consumer has a critical role in returning waste electronic/electrical equipment for recycling and disposal.

(d)Recycling keeps these products out of the municipal waste stream.

(e)The crossed-out bin symbol is a reminder to follow these points.

(f)Please contact your local authority or local dealer and ask for further details regarding the correct method of disposal.

Fig. 38

Fig. 39

14hrs

14

Page 14
Image 14
Hayter Mowers 410G, 412G, 413G manual Battery Charging Code 412 only, Refer, Mower Maintenance