1.40

OPERATING THE MOWER

1.40

MK3 200mm FIXED CUTTERHEAD

A

Pivot knuckle fixing: Secure the bolt in the front “fixed” hole position ‘A’ as shown.

1D876P05A

Height of cut adjustment: The height of cut is gauged by the position of the rear roller.

Turn the adjusting nut assembly ‘B’ both ends clockwise to decrease height of cut ‘E’ or anti-clockwise to increase height of cut ‘E’.

IMPORTANT: PREVENT DAMAGE - Do not attempt to unlock the nut assemblies, ‘B’.

Ensure that all cutterheads are set at the same height of cut by either referring to the indicator rings ‘C’ or by using a height of cut gauge across the full width of each cutterhead for greater accuracy as shown.

B

E

1D876P08B

C

E=

1D876P09A

MK3 254mm FIXED CUTTERHEAD

Height of cut adjustment: The height of cut is gauged by the position of the rear roller.

Turn the adjusting nut assembly ‘B’ both ends clockwise to decrease height of cut ‘E’ or anti-clockwise to increase height of cut ‘E’.

IMPORTANT: PREVENT DAMAGE - Do not attempt to unlock the nut assemblies ‘B’.

Ensure that all cutterheads are set at the same height of cut by either referring to the indicator rings ‘C’ or by using a height of cut gauge across the full width of each cutterhead for greater accuracy as shown.

B

E

1D876P16A

C

E=

1D876P09A

924916KG251004