1.41 | OPERATING THE MOWER | 1.41 |
MK3 200mm FLOATING CUTTERHEAD
A
Pivot knuckle fixing: Secure the bolt in the rear “floating” slot position ‘A’ as shown.
1D876P07A
Height of cut adjustment: The height of cut is gauged by the position of the front and rear rollers.
To alter the rear roller position, turn the adjusting nut assembly ‘B’ both ends clockwise to decrease height of cut ‘E’ or
IMPORTANT: PREVENT DAMAGE - Do not attempt to unlock the nut assemblies, ‘B’.
To alter the front roller position loosen bolts ‘F’. Release and turn adjusting nuts ‘D’ both ends clockwise to increase the height of cut or
Ensure that all cutterheads are set at the same height of cut by referring to the indicator rings ‘C’ or use the height of cut gauge across the full width of each cutterhead as shown.
Tighten nuts ‘D’ and ‘F’ both ends.
B
D 
FA
E
1D876P06B
C
E=
1D876P10A
CENTRE CUTTERHEAD HEIGHT OF CUT CORRECTION ADJUSTMENT
With all cutterheads set at the same HOC via the indicator rings, it may be noticeable that the centre unit produces a higher cut finish compared to the wing units. The centre unit is pulled and the wing units are pushed this presents marginally different cutting angles relative to the ground. The amount of HOC variation, which results from this will be influenced by the terrain but satisfactory results can usually be achieved by setting the centre cutterhead HOC indicator ring lower than the wing unit settings.
924916KG251004