Healthrider HRTL61706.1 manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex key and your own phillips screwdriver .

Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly.

3/4" Screw (23)–6			1” Tek Screw (77)–4		1 1/4” Tek Screw (108)–2	Cover Screw (52)–4
3/8" Star		Pulse Bar Star		Endcap Screw	Silver Pulse Bar	Console Screw (67)–4
		Washer (65)–4		(79)–2	Screw (64)–4
Washer (83)–4
2	3/4" Upright Bolt (85)–2			1" Upright Bolt (84)–2		1 1/4" Bolt (63)–4

1. Make sure that the power cord is unplugged.		76
1	75
With the help of a second person, carefully tip
the treadmill onto its left side as shown. Partially
fold the Frame (26) so that the treadmill is more		Post
stable. Do not fully fold the Frame until the
treadmill is completely assembled.		Wire
Identify the Right Upright (76) which has a
RIGHT sticker. Hold the Right Upright near the	76
Base (81). Insert the Upright Wire (75) into the
Right Upright until the Upright Wire is extending
from the upper end of the Right Upright. Note:	81
Make sure that the Upright Wire is extending			85
from the side of the post as shown in the inset
drawing. Remove the tie from the Upright Wire.	26
Thread a 2 3/4" Upright Bolt (85) and a 1" Upright		83	84
Bolt (84) with 3/8" Star Washers (83) into the
Base (81) and the bottom of the Right Upright
(76). Do not tighten the Upright Bolts yet.
6