Hearth and Home Technologies ST36D owner manual Chase Installations, Construct the Chase

9 Chase Installations

A. Construct the Chase	Gas line holes and other openings should be caulked with
A chase is a vertical boxlike structure built to enclose the	high temperature caulk or stuffed with unfaced fiberglass
	insulation. If the fireplace is being installed on a cement
fireplace and/or its vent system. Vertical chimneys that
	slab, we recommend that in cold climates, a sheet of
run on the outside of a building must be installed inside a
	plywood or other raised platform be placed underneath to
chase.
	prevent conducting cold up into the room.
Construction of the chase may vary with the type of build-
	Three examples of chase applications are shown in Fig-
ing. These instructions are not substitutes for the require-
	ure 9.2.
ments of local building codes. Local building codes MUST
be checked.	1. Chimney offset through exterior wall and
A chase should be constructed in the manner of all
	enclosed in chase.
outside walls of the home to prevent cold air drafting	2. Chase constructed on roof.
problems. The chase should not break the outside build-
ing envelope in any manner. All outer walls need to be
insulated.

Building codes require false ceiling and ceiling firestops at each floor of the chase or every 10 ft (3.05 m) of clear space to control spread of fire.

Walls, ceiling, base plate and cantilever floor at the first level of the chase should be insulated. See Figure 9.1. Vapor and air infiltration barriers should be installed in the chase as per regional codes for the rest of the home. Ad- ditionally, Hearth & Home Technologies recommends that the inside surfaces be sheet rocked and taped (or the use of an equivalent method) for maximum air tightness.

				1	2
Round Termination Cap			Figure 9.2	Chase Constructions
Metal Chase Top
Ceilng			WARNING! You must install false ceilings and ceiling
Firestop
			firestops at each floor of the chase or every 10 ft (3.05 m)
			to control spread of fire.
			WARNING! Risk of Fire! DO NOT seal area between fire
			stop opening and chimney pipe. Restricting air flow around
			chimney may cause fire.
False Ceiling			WARNING! Risk of Fire! You must maintain a minimum
			2 in. (51 mm) air space clearance to insulation and other
			materials surrounding the chimney system.
		Attic	• Insulation and other materials must be firmly secured to
Tabs		Insulation
		Shield	prevent accidental contact with chimney system.
		Ceiling	• The chase must be properly blocked to prevent blown
		Firestop	insulation or other combustibles from entering and
Insulation		Insulation	making contact with fireplace or chimney.
False Ceiling		False Ceiling	• Failure to prevent contact between insulation or other
		Chimney	materials and chimney system may cause overheating
			and fire.
Figure 9.1	Chase Assembly
32			Heatilator • ST36D • 20396 • Rev AA • 11/08