Heat Controller MMC24DA-1, MMC18DA-1 Remote Control Operation, Nd F Button, Signal transmitter

Operating Instructions

RemoteControlOperation

The Remote Controller transmits the signals to the system.

Signal transmitter

5			1
6
			3
4
2		CANCEL	10
7	OFF	SET	9
ON			12
11		AUTO CLEAN
8			15
			16

13 14

Flip-up door (opened)

Operation Mode

Cooling Operation

Auto Operation or Auto Changeover

Healthy Dehumidification Operation

Heating Operation

• Cooling Model(), Heat Pump Model( )

1. START/STOP BUTTON

Operation starts when this button is

pressed and stops when the button is pressed again.

2. OPERATION MODE

SELECTION BUTTON (Heat Pump) (Cooling Only)

Used to select the operation mode.

3. ROOM TEMPERATURE SETTING BUTTONS

Used to select the room temperature.

4. INDOOR FAN SPEED SELECTOR Used to select fan speed in four steps low, medium, high and CHAOS.

5. JET COOL

Used to start or stop the speed cooling/heating.(speed cooling/heating operates super high fan speed.)

6. CHAOS SWING BUTTON

Used to stop or start louver movement

and set the desired up/down airflow direction.

7.ON/OFF TIMER BUTTONS

Used to set the time of starting and stopping operation. (See page 18)

8.TIME SETTING BUTTONS

Used to adjust the time. (See page 18)

9.TIMER SET/CANCEL BUTTON

Used to set the timer when the desired time is obtained and to cancel the Timer operation. (See page 18)

10.SLEEP MODE AUTO BUTTON

Used to set Sleep Mode Auto operation. (See page 18)

11.AIR CIRCULATION BUTTON

Used to circulate the room air without cooling or heating. (See page 19)

12.ROOM TEMPERATURE CHECKING BUTTON Used to check the room temperature.

13.RESET BUTTON

Used prior to resetting time.

14.2nd F Button

Used prior to using modes printed in blue at the bottom of buttons. (See page 17)

15.AUTO CLEAN

Used to set Auto Clean mode.

16.˚C TO ˚F SWITCHING BUTTON

Used to switch temperature reading from Centigrade to Fahrenheit.

Owner's Manual 11