Heath Zenith 4350 manual Manual Mode, Requirements, Operation, Test, Auto, Mode Switching Summary

Before installation, record the model number listed inside the fixture.Attach receipt in case

MANUAL MODE

of possible warranty issues.

Model Number:

REQUIREMENTS

•The Light Control requires 120 volts AC.

•If you want to use Manual Mode, the control must be wired through a switch.

•Some electrical codes require installation by a qualified electrician.

OPERATION

Manual mode only works at night because daylight returns the sensor to AUTO.

Flip the light switch off for one second then back on to toggle between AUTO and

MANUAL MODE.

Manual mode works only with the ON-TIME switch in the 1, 5, or 10 position.

1 Second OFF

then...

Mode:	On-Time	Works: Day Night
Test	5 Sec	x	x
Auto	1, 5, or 10 min		x
Accent	Off, 3, 6 Hr, to Dawn		x
Manual	Until Dawn*		x

* resets to Auto Mode at dawn.

Note: When first turned on wait about 1 1/2 minutes for the circuitry to calibrate.

TEST

Set the ON-TIME switch	ON-TIME
on the sensor to TEST.

TEST 1 5 10 MIN

AUTO

Set ON-TIME switch to		ON-TIME
1, 5, or 10 minutes.
	TEST 1 5 10 MIN

... back on.

MODE SWITCHING SUMMARY

	TEST	ON-TIME Switch at 1, 5, or
		10 minutes
	AUTO		Flip light switch off
			for one second then
MANUAL MODE			back on*

*If you get confused while switching modes, turn the power off for one minute, then back on. After the cali- bration time the control will be in the AUTO mode.

DUALBRITE® DIMMER CONTROL

Light comes on half power for selected time after dusk (Off, 3 hr., 6 hr., until dawn). If motion is sensed, the light turns on full power for the ON-TIME (1, 5, or 10 minutes) then returns to accent mode.

2 598-1219-04