Final Assembly
1.Push the wires into the junction box. Make sure none of the wires get pinched.
2.Slide the fixture assembly onto the mounting screws. Tighten decorative nuts removed in step 1 of Installation section securely against fixture base.
Decorative Nut
Mounting Screw
Junction Box
3.Install one medium base light bulb (100 Watt maxi- mum).
4.Place top cover onto fixture and attach using the two decorative nuts (included). Hand tighten only.
5.After completing the tests on page 5, caulk around fixture base with silicone weather sealant.
Decorative Nut
Top Cover
Light Bulb (100
Watt Maximum)
Fixture Assembly
Caulk Around
Fixture Base
Testing and Adjustments
1.Turn on the circuit breaker and light switch.
Note: Sensor has a 1 1/2 minute warm up period before it will detect motion. When first turned on wait 1 1/2 minutes.
2.Set:
ON-TIME switch to TEST SENSITIVITY dial to Midway
–+
SEN
TEST 1 5 10
MINUTE
3.Walk through the coverage area noting where you are when the lights turn on. In TEST mode, light will stay on for 5 seconds after sensing motion and then turn off.
4.Adjust the SENSITIVITY to increase or decrease the range as needed. Too much sensitivity may cause false triggering due to heat sources in the coverage area (see Adjustment of Coverage Area or Troubleshooting section).
5.Set the amount of
| 180° |
6 ft. |
|
(1.8 m) |
|
| 30 ft. |
| (9.1 m) |
Maximum Range | Maximum |
| Coverage Angle* |
| (Top View) |
