To Deactivate the Flash Alert
WARNING: Turn power off at circuit breaker or fuse.
❒Remove the light fixture if necessary.
❒Locate the (Blue) wire loop coming from the sensor inside the canopy.
❒Cut the (Blue) wire loop.
❒Securely attach wire nuts (supplied) to each of the cut ends of the (Blue) wire. DO NOT connect the wires together.
❒Mount light control to wall or eave.
TEST AND ADJUSTMENT
❒Turn on the circuit breaker and light switch.
NOTE: Sensor has a 1 1/2 minute warm up period before it will detect motion. When first turned on, wait 1 1/2 minutes.
❒Turn the SENSITIVITY (SENS) control to the mid posi- tion and the
| SENS | |||||||
| ||||||||
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
10 5 1 TEST
MIN MAX
Bottom of Sensor
Flash Alert - Deactivated
(Blue)
Mount the Light Control
❒Align the light control cover plate and the junction box holes. Secure with the mounting screws.
❒If not installed on a weatherproof box or if an adaptor plate (not included) was used, caulk the wall plate and mounting surface with silicone.
Avoid water damage and electrical shock - keep lamp holders below horizontal.
Lock nuts
Keep lamps at least 1" (25 mm) from the sensor.
❒Adjust the lamp holders by loosening the lock nuts but do not rotate the lamp holders more than 180° from the factory setting.When screwing in the flood- lamps, do not overtighten.