1.Remove back of push button. To remove back of push button, push in tab on bottom with a small screwdriver. Pull battery tab to activate factory installed batteries.
2.Set the push button dip switches to match the chime receiver code. See Code and Tune Setting section.
Pull tab to activate
batteries
3.Test range. Temporarily position push button where you want it mounted. Press push button to verify chime and push button work properly. If chime does not sound, see Troubleshooting.
4.Mount push button. Use either screws or double sided tape to mount push button.
•To mount with screws, remove back of case by pushing in tab on bottom with a small screwdriver. Remove material in screw hole. Attach back of case to door jamb or wall with screws provided. Snap front of push button on.
•When attaching push button using double sided tape, make sure the surface of the door jamb or wall is clean.
This End | Remove material in | |
Up | ||
screw hole before | ||
| ||
| mounting with | |
| screws |
- - |
