Toggle Switch
Master Switch
Figure 2 - Receiver's Master Switch
9.If not already there, slide the receiver's master switch, located beside the toggle switch to its ON (up) position. The light may turn on at this time. NOTE: If you are controlling a lamp, make sure it is connected to the switched outlet and that the lamp is switched on.
10.Slide the receiver’s master switch to its OFF (down) position. Move the toggle switch up and down. The light should remain off.
11.Slide the receiver’s master switch to its ON (up) position. Move the switch lever up and down. The light should switch on and off.
12.Install the
IMPORTANT: Wait at least 1 second after you switch the transmitter on or off before you switch it again to allow the transmission to be completed each time.
13.To verify proper operation, hold the transmitter at the desired mounting location and switch it on. The light should turn on immediately. Turn the light off and back on. If the light intermittently turns on or does not turn on at all, move the transmitter slightly and try again. If it still does not operate properly, perform step 14, otherwise, skip the step.
14.Unwind the antenna on the receiver from its track. Route the antenna through the notch and fully extend it so that it hangs down inside the wall (see Figure 3). This will increase the range of the receiver. Reposition the transmitter at the desired location and make sure it operates the light. You may have to re- position the receiving antenna or the transmitter until the light works properly.
15.Mount the transmitter at the desired location with the two wood screws that are provided. NOTE: If your mounting surface requires a different type of mounting hardware, please purchase the necessary hardware.
- - |
