1.Install two lithium type CR2032 3 volt bat- teries (included). Remove back of case by pushing in tab on bottom with a small screw-
driver. Make sure battery is oriented properly (see page 5).
2. Set the push button jumpers to match the 
chime receiver code. See “Code and Tune Setting” section.
3.Test range. Temporarily position push button where you want it mounted. Press push button to verify chime and push button work properly. If chime does not sound, see Troubleshooting.
4.Mount push button. Use either screws or double sided tape to mount push button.
•To mount with screws, remove back of case by pushing in tab on bottom with a small screwdriver. Attach back of case to door jamb or wall. Snap front of push button on.
•When attaching push button using double sided tape, make sure the surface of the door jamb or wall is clean.
- - |
