Heath Zenith manual Operation, Model SL-5710, Motion Sensor Light Control, On-Time, Test, Auto

Motion Sensor

Light Control

Model SL-5710

Features

• Turns on lighting when motion is detected.

• Automatically turns lighting off.

• Photocell keeps the lighting off during daylight hours.

OPERATION

Mode:	On-Time	Works: Day	Night
Test	5 Seconds	x	x
Auto	1, 5, or 10 Min		x
Manual	Until Dawn*		x

* resets to Auto Mode at dawn.

Note: When first turned on wait about 1 1/2 minutes for the circuitry to calibrate.

TEST

Put the ON-TIME switch on the bottom ON-TIMEof the sensor in the TEST position.

10 5 1 TEST

AUTO

•	LED indicates motion was sensed (day or night).
•	Additional energy savings with compact fluorescent
	bulbs.

This package includes:

Lamp Holders

Rubber Plug

Put the ON-TIME switch in the 1, 5, or 10 minute position.Note: Although the 1 minute mode can be used, the 5 or 10 minute mode is recommended for best operation and performance when using compact fluorescent bulbs.

ON-TIME

10 5 1 TEST

Plastic Hanger

Cover Plate Sensor

MANUAL MODE

Manual mode only works at night because daylight returns the sensor to AUTO.

Flip the light switch off for one second

Light Control

2 Wire

then back on to toggle between AUTO and MANUAL MODE.

1Second OFF then...

Connectors

Mounting Bolt Mounting Strap

Manual mode works only with the ON-TIME switch in the 1, 5, or 10 position.

... back on.

Gasket

6 Screws

2 Compact (3 sizes included) Fluorescent Bulbs

Requirements

•The light control requires 120-volts AC.

•If you want to use Manual Mode, the control must be wired through a switch.

•Some codes require installation by a qualified electrician.

•This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations.

•Note:This product is not recommended for use where the outside temperature is below -10° F.

Mode Switching Summary

	TEST	Move ON-TIME Switch to
			1, 5, or 10 minutes
	AUTO		Flip light switch off
			for one second then
			back on*
MANUAL MODE

*If you get confused while switching modes, turn the power off for one minute, then back on. After the cali- bration time the control will be in the AUTO mode.

© 2007 HeathCo LLC 598-1120-04