Hellenbrand WM2-IC-2.0 manual Model Number, Max. Service, Flow Rate GPM, Backwash

Better in the bath. Better in the laundry. Better from the faucet.

NEW! IC-2.0 Technology Upgrade

The new IC-2.0 technology marks the first major upgrade to the original and proven 1992 patented Iron Curtain System. Since then, the Iron Curtain System has been called the most reliable and best iron and sulfur (rotten egg odor) system design by leading water treatment professionals in the industry. This new technology gives you:

•Individual factory by-pass valves for both the aeration tank and filter tank assemblies.

•Reduced installation materials.

•Reduced installation time.

•Reduction in regeneration water.

•Independently time controlled air recharge cycles up to six times per day for greater oxidation capabilities.

•Non-metallic valve body.

•Built-in pressure relief valve.

•Less service on air compressor and longer life.

•Modular design for ease of service.

The Iron Curtain

•Requires no chemicals or salt for operation or regeneration.

•Requires no air injectors, venturis or micronizers.

•Removes concentrations of dissolved and precipitated iron.

•Increases the pH of acid water on type “A” systems.

The Iron Curtain Filtration System is available in single, twin, tri- plex and four-plex filter configurations covering a wide range of flow rate applications from 5 gpm (gallons per minute) to over 450 gpm. There is a Hellenbrand Iron Curtain Filtration System for virtually any residential or commercial need.

Hellenbrand Warranty

Hellenbrand warranties every Iron Curtain Filtration System in accordance with the Magnuson-Moss Warranty Act. Ask your Iron Curtain Dealer for full details.

No Obligation Water Analysis

Your Hellenbrand dealer will be happy to test your water to determine the best system for you. Always have your water tested before you purchase a water treatment system.

Model Number	Max. Service	Backwash
	Flow Rate (GPM)	Flow Rate (GPM)
WM2-IC10 2.0	5.0	5.0
WM2-IC12 2.0	7.0	8.0
WM2-IC13 2.0	8.0	10.0

1.Maximum service flow rates are for intermittent household use only.

2.Minimum of 30 psig required at backwash flow rates listed.

3.Water temperatures above 60˚F will require higher backwash rates.

4.Always have your water tested before you purchase any water treatment system.

5.See owner’s manual for specific operating conditions and limitations.

6.Contact your dealer or factory for larger flow rate applications.