BRE100.2 2-CHANNEL Amplifier Applications, VIA Fuse

BRE100.2 2-CHANNEL AMPLIFIER APPLICATIONS

This is the most basic application for the ELITE Series 2 channel amplifiers.

1. Interconnect cable checklist:

Connect the LINE INPUTS to the Radio/CD with good quality RCA cables.

2. Crossover Switch:

The X-OVER switch must be in the FULL position.

3.Crossover frequency control checklist: N/A for full range operation.

4. Line Level:

Refer to the section “Setting up systems after installation for best performance”

NOTE: Minimum final loudspeaker impedances:

4 & 2 Ohms stereo mode or 4-Ohms mono mode

This amplifier will not do 1 Ohm stereo or 2/1 Ohm mono operation.

This application illustrates the basic mono bridging method for all Hifonics	Switch setting checklist:
amplifiers.	- The AMPLIFIER X-OVER switch should be in the LP/BP position.
Interconnect cable checklist:	Crossover frequency control setting checklist:
A MONO signal source is required, such as would be available from the mono	LPF: 11 o’clock
sub bass output of an active crossover, whether stand alone, or built into a head
unit or equalizer. Important: Do not be tempted to connect the hot, or positive	Minimum final loudspeaker impedance:
outputs, from any source together to obtain a mono signal, as this could very	- 4 ohm mono.
well damage the output stage of that source.
It is necessary to feed the SAME signal to both left and right inputs via a Y-
adapter RCA cable. Connect the mono speaker positive terminal to the LEFT +,
and its negative terminal to RIGHT -.

BRUTUS

ELITE