Hilti WSR1250-PE Basic information concerning safety, General safety precautions, Mechanical

may be suitable for one tool may become hazardous when used on another tool.

6. Service

Tool service must be performed only by qualified repair personnel. Service or maintenance per- formed by unqualified personnel could result in a risk of injury.

When servicing a tool, use only identical replace- ment parts. Follow instructions in the Maintenance section of this manual. Use of unauthorized parts or failure to follow Maintenance Instructions may create a risk of electric shock or injury.

en

3. Specific safety rules and symbols

3.1 Basic information concerning safety

In addition to the information relevant to safety given in each of the sections of these operating instructions, the following points must be strictly observed at all times.

-WARNING-

Read all safety precautions and instructions! Failure to observe the following safety precautions and instruc- tions may lead to electric shock, fire and/or serious injury.

3.2Take the necessary precautions to make the workplace safe

●Ensure that the workplace is well ventilated.

●Keep the working area tidy. Objects which could cause injury should be removed from the working area. Untidi- ness at the workplace may lead to accidents.

●Keep the area above and below the cutting line free of obstacles.

●Wear suitable working clothing. Wear a hair net if you have long hair.

●Do not permit other persons to touch the electric tool or the extension cord.

●Avoid unusual body positions. Work from a secure stance and stay in balance at all times.

●To avoid tripping and falling when working, always lead the supply cord and extension cord away to the rear.

●Concealed electric cables or gas and water pipes pre- sent a serious hazard if damaged while you are work- ing. Accordingly, check the area in which you are work- ing beforehand (e.g. using a metal detector).

●Unknown base materials should be examined in order to avoid personal injury or the possibility of cutting into pipes or cables. Use the right blade for the mate- rial being cut.

●Do not cut unless there is proper clearance beyond the workpiece being cut. The blade may cause the tool to kick-back if it strikes a hidden object.

●Before cutting pipes, always first ensure that the pipes contain no liquids. Empty the pipes if necessary. The tool is not water or moisture proof. Liquids running out may cause a short circuit in the tool resulting in an electric shock being received. When cutting pipes, hold the tool so that it is higher than the pipe being cut.

3.3General safety precautions

●To ensure efficient and safe operation, the contact shoe of the tool must be pressed against the work- piece .

●Keep the tool, especially its grip surfaces, clean and free from oil and grease.

●Always hold the tool securely, with both hands on the

grips provided . Make sure to grip the tool and posi- tion your hands and fingers so they will not contact or slip into the area of the blade clamp or saw blade.

●Switch on the tool only after it has been brought into position where the cut is to be made.

●Do not start the tool with the blade contacting the work surface.

●When cutting, always guide the tool away from the body.

●Switch the tool off before transporting it.

●Always allow the tool to come to a complete stop before removing it from the workpiece.

●Never place your hands in front of or on the saw blade.

●Check the tool for possible damage. Protective devices and any parts that may have suffered slight damage should be checked for correct operation and func- tionality before further use of the electric tool. Safety devices or other parts that are found to be damaged must be replaced or repaired properly by an autho- rized repair workshop unless otherwise indicated in the operating instructions.

●Always use saw blades of adequate length. To help avoid kick-back while sawing, the blade must always project at least 40 mm (1.5 in) beyond the workpiece

during the stroke cycle .

3.3.1Mechanical

●Ensure that the saw blades used are equipped with the correct connection end system and that they are prop- erly fitted and secured in the blade clamp.

3