USING THE REMOTE TO CONTROL VCR FUNCTIONS
USING THE REMOTE TO CONTROL VCR FUNCTIONS
Operating the
This remote is designed to operate different types of VCR's. You must first program the remote to match the remote system of your VCR. (Refer to page 30.)
Remote Control Illustration
1.Set the
2.Turn ON your VCR.
3.Aim the remote control at the front of your VCR.
4.While holding down the VCR POWER button on the remote, enter the 2 digit preset code that matches your VCR as shown on page 30. The remote will turn off your VCR when the correct 2 digit preset code is entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off after 5 seconds, try a different 2 digit preset code.
5.The remote will now control your VCR.
NOTES:
1.If your VCR cannot be operated after performing the above procedures, this means that your VCR code has not been precoded into the remote.
2.In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult your VCR operating guide.
3.The remote control will remember the codes you have programmed in until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure stated above.
4.If your VCR does not have a power function, the remote will issue the CHANNEL UP function.
5.The MENU button will act as the VCR MENU button for HITACHI VCR's.
6.The
7.The SLEEP button will act as your VCR +100 button if required.
1 PRECODED VCR buttons
These buttons transmit the chosen precoded VCR codes.
2 EXCLUSIVE TV buttons
These buttons are for operating the TV.
35