USING THE REMOTE TO CONTROL CABLE BOX/SATELLITE FUNCTIONS
USING THE REMOTE TO CONTROL CABLE BOX/SATELLITE FUNCTIONS
Operating the
This remote is designed to operate different types of cable boxes and Digital Satellite Systems. You must first program the remote to match the remote system of your cable/satellite box. (Refer to page 30.)
Remote Control Illustration
1.Set the
2.Turn ON your cable/satellite box.
3.Press the CATV button on the remote to switch to CATV mode.
4.Aim the remote control at the front of your cable/satellite box.
5.While holding down the CABLE POWER button on the remote, enter the 2 digit preset code that matches your VCR as shown on page 30. The remote will turn off your cable/satellite box when the correct 2 digit preset code is entered. When this occurs, the remote control is programmed for your cable/satellite box. If the cable/satellite box does not turn off after 5 seconds, try a different 2 digit preset code.
6.The remote will now control your cable/satellite box.
NOTES:
1.If your cable/satellite box cannot be operated after performing the above procedures, this means that your VCR code has not been precoded into the remote.
2.In the unlikely event that your cable/satellite box cannot be operated after performing the above procedures, please consult your cable/satellite box operating guide.
3.The remote control will remember the codes you have programmed in until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure stated above.
4.If your cable/satellite box does not have a power function, the remote will issue the CHANNEL UP function.
5.The
7. The SLEEP button will act as your cable/satellite box +100 button if required.
1 PRECODED CABLE/SATELLITE buttons
These buttons transmit the chosen precoded CATV/Satellite codes.
2 EXCLUSIVE TV buttons
These buttons are for operating the TV.
36