2.If a channel is tuned during this SURF scanning, sub-pictures will be removed from the screen.

(2)SWAP Button

If you wish to switch what is being shown on the main picture to the Sub-Picture, press the SWAP button.

NOTE: 1. The SWAP button will only operate when SINGLE PIP mode is chosen.

2.The SWAP function will not operate if ANT B input is set as the main channel (ANT B input cannot be displayed as a sub-picture.)

(3)MOVE Button

To move the sub-picture to another corner, press the MOVE button. The sub-picture moves one step conterclockwise every time the MOVE button is pressed. (Example below illustrates the MOVE operation for initial shipping conditions. If you have customized a PIP position, the MOVE operation may differ slightly from this example).

It is also possible to customize the PIP position. To do this, wait until the On-Screen Display disappears (about eight seconds) and then use the CURSOR , , , buttons.

(4) FREEZE (FRZ) Button (With PIP ON)

If you wish to freeze the Sub-Picture, press the FRZ button. This is convenient when trying to write down the address for a mail order company, recording statistics for a sporting event, etc. To return the picture to motion, press the FRZ button again.

NOTE: The FREEZE function will only operate when SINGLE PIP mode is chosen.(5) FREEZE (FRZ) Button (With PIP OFF)

Press the FRZ button to freeze one or four frames of the picture, depending on the mode previously selected (SINGLE or

STROBE). To change FREEZE modes, use cursor or to select which type of FREEZE mode you wish to view. The new selection will appear the next time the FREEZE function is used.

SINGLE FREEZE

Press the button to freeze one frame of the picture you are currently viewing. Press this button again or PIP to return to normal viewing.