NOTE: Check and make sure on a periodic basis if the position of the laser line is in order. As regards the checking method, draw a right-angle ink line on the workpiece with the height of about 20mm (25/32") and the width of 150mm (5-29/32"), and check that the laser line is in line with the ink line [The deviation between the ink line and the laser line should be less than the ink line width (0.5mm)]. (Fig. 23)

PRACTICAL APPLICATIONS

WARNING: * To avoid personal injury, never remove or place a workpiece on the table while the tool is being operated.

*Never place your limbs inside of the line next to warning sign while the tool is being operated. This may cause hazardous conditions (see Fig. 24).

Line

Warning Sign

Warning Sign

Line

 

 

Fig. 24

1.Switch operation

Switch operation the tool is turned on when the switch trigger is pulled and off when the trigger switch is released.

2.Using the Vise Assembly (Standard accessory)

 

Screw Holder

6mm

Knob

Knob Bolt

 

Vise Plate

V-Groove

Groove

Workpiece

Fence

6mm Knob Bolt

Fig. 25

The vise assembly can be mounted on either the left fence (Fence (B)) or the right fence (Fence (A)), and can be raised or lowered according to the height of the workpiece.

To raise or lower the vise assembly, first loosen the 6mm knob bolt. As shown in Fig. 25, the vise shaft has three locking grooves into which the tip of the 6mm wing bolt is designed to fit in order to lock the screw holder in the desired position.

To ensure that the tip of the 6mm wing bolt is properly aligned with the desired locking groove on the vise shaft, simply align the upper surface of the fence to either of three v-grooves on the vise shaft surface or to the lower surface of the screw holder.

18