30° and 33.9° left slant setting method
Fixing pin Holder (A)
| Clamp Lever |
| Tighten |
| Push |
Bevel Scale | Loosen |
Indicator
(for left bevel scale) Fig. 36
(1)Loosen the clamp lever and slant to the left a little at a time while pushing the fixing pin into the main unit. At this time, the fixing pin will enter one step and fit into the 30° left slant and 33.9° left slant setting slots.
(2)With the fixing pin in the slot as described above, setting to the 30° left slant position is possible by pushing to the right side.
(3)Also, with the fixing pin in the slot as described above, setting to the 33.9° left slant position is possible by pushing to the left side.
(4)Look at the bevel scale and indicator to recheck whether or not the settings match and then tighten the clamp lever.
(1)Setting to cut crown moldings at positions 1and 4in Fig. 35 (see Fig. 37; tilt the motor head to the left):
1 Turn the turntable to the right and set the Miter Angle as follows:
*For 45° type crown moldings: 35.3° ( mark)
* For 38° type crown moldings: 31.6° ( mark)
2Tilt the motor head to the left and set the Bevel Angle as follows:
*For 45° type crown moldings: 30° ( mark)
* For 38° type crown moldings: 33.9° ( mark)
3Position the crown molding so that the upper surface (A in Fig. 34) contacts the fence as indicated in Fig. 39.
(2)Setting to cut crown moldings at positions 2 and 3 in Fig. 35 (see Fig. 38; tilt the head to the left):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings: | 35.3° ( |
| mark) |
* For 38° type crown moldings: | 31.6° ( |
| mark) |
|
2Tilt the head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings: | 30° ( |
| mark) | |
* For 38° type crown moldings: | 33.9° ( |
| mark) | |
| ||||
3Position the crown molding so that the lower surface (B in Fig. 34) contacts the fence as in Fig. 40.
| Head |
|
| Head |
|
| Bevel Angle Scale |
| Bevel Angle Scale | ||
|
| 3 | |||
|
|
| 2 | ||
|
|
|
|
| |
1 |
| 4 | Fence |
|
|
|
| Fence |
|
| |
|
|
|
|
| |
|
| Base |
|
| Base |
|
|
|
| Turntable | |
| Turntable | Miter Angle Scale | |||
Miter Angle Scale |
| ||||
|
|
| |||
|
|
|
|
| |
| Fig. 37 |
|
| Fig. 38 |
|
24