26
WARNING: Always firmly clamp or vise to secure the crown molding to the fence; otherwise the crown molding might be thrust from the table and cause bodily harm.
Do not bevel cutting. The main body or saw blade may contact the sub fence, resulting in an injury.
Fig. 45-b
Crown molding Stopper (L) Crown molding Stopper (R) (optional accessories)
6mm wing bolt
Crown molding
Fence
Groove
V-Groove
Knob
6mm Knob Bolt
Crown molding Vise Ass’y (optional accessories)
(2) The crown molding vise (B) (Optional accessory) can be mounted on either the left fence (Fence (B)) or the right fence (Fence (A)). It can unite with the slope of the crown molding and vice can be pressed down.
Then turn the upper knob, as necessary, to
securely attach the crown molding in position. To raise or lower the vise assembly, first loosen the 6mm knob bolt. As shown in Fig. 45-b, the vise shaft has three locking grooves into which the tip of the 6mm wing bolt is designed to fit in order to lock the screw holder in the desired position.
To ensure that the tip of the 6mm wing bolt is properly aligned with the desired locking groove on the vise shaft, simply align the upper surface of the fence to either of three v-grooves on the vise shaft surface or to the lower surface of the screw holder.
Therefore, the vise assembly can be attached in either of three positions to ensure proper height adjustment.
After adjusting the height, firmly tighten the 6mm wing bolt; then turn the upper knob, as necessary, to securely attach the crown molding in position. (see Fig. 45-b)
6mm
Knob Bolt
6mm
Wing Bolt Crown molding Stopper (L) (optional accessories)
Fig. 45-a

Cutting method of crown molding without tilting the saw blade.

Crown molding

Crown molding

Stopper (R)

Vise Ass’y

 

 

(optional

(optional

 

 

accessories)

accessories)

6mm

 

Knob Bolt

(1)Crown molding Stopper (L) and (R) (optional accessories) allow easier cuts of crown molding without tilting the saw blade. Install them in the base both-sides side to be shown in Fig. 45-a. After inserting Tighten the 6mm knob bolts to secure the crown molding Stoppers.

[Optional accessories used]

•Crown molding Vise Ass’y (Include Crown molding Stopper (L))

•Crown molding Stopper (L)

•Crown molding Stopper (R)