CAUTION: Always confirm that the motor head (see Fig. 1) does not contact the crown molding vise ass’y when it is lowered for cutting. If there is any danger that it may do so, loosen the 6mm knob bolt and move the crown molding vise ass’y to a position where it will not contact the saw blade.
Position crown molding with its WALL CONTACT EDGE against the guide fence and its CEILING CONTACT EDGE against the crown molding Stoppers as shown in Fig.
Tighten the 6mm wing bolt to secure the crown molding Stoppers. Refer to the lower table for the miter angle.
| Position in Fig. 35 | Miter angle | Finished piece | |
|
|
|
| |
For inside corner | 1 | Right 45° | Save the right side of blade | |
|
|
|
| |
| 2 |
| Save the left side of blade | |
|
| Left 45° |
| |
For outside corner | 3 | Save the right side of blade | ||
| ||||
|
|
|
| |
| 4 | Right 45° | Save the left side of blade | |
|
|
|
|
Use the sub fence (A) (optional accessories) to secure the crown molding more firmly. (see Fig. 15)
11. Groove cutting procedures
| 8mm Wing Nut | ||
Cut grooves with |
|
| |
saw blade |
|
| |
| 8mm Depth |
| |
a | Adjustment Bolt |
| |
b | Gear Case | ||
| |||
b | Bottom Line of | Turntable | |
| |||
| the Groove |
| |
Fig. 46 | Fig. 47 |
| |
Grooves in the workpiece can be cut as indicated in Fig. 46 by adjusting the 8mm depth adjustment bolt.
Cutting depth adjustment procedure:
(1)Loosen the 8mm wing nut and turn the 8mm depth adjustment bolt by hand.
(2)Adjust to the desired cutting depth by setting the distance between the saw blade and the surface of the base (see b in Fig. 46).
(3)The 8mm wing nut must be properly tightened after the adjustment has been completed.
NOTE: When cutting a single groove at either end of the workpiece, remove the unneeded portion with a chisel.
27