English
ADJUSTSING THE SAW PRIOR TO USE
WARNING:
To avoid serious accidents, ensure the switch is in OFF position, and disconnect the plug from the receptacle.
1.Adjusting the cutting depth (Fig. 3)
WARNING:
If the lever (A) is loose, injury can result. Tighten it securely after adjustment.
To adjust cutting depth, loosen the lever (A) and, while holding the base with one hand, move the main body up and down to obtain the prescribed cutting depth. After adjusting to the prescribed cutting depth, tighten the lever (A) securely.
Loosen
Lever (A)
Tighten
Base
Fig. 3
2.Adjusting the angle of inclination
WARNING:
If the lever (A) is loose, injury can result. Tighten it securely after adjustment.
You can incline saw blade from 0˚ to a maximun angle of 55˚ in relation to the base.
As shown in Fig. 4 by loosing the lever (A) on the bevel scale, the saw blade may be inclined to an angle of 45˚ in relation to the base.
Lever (A)
0˚ – 45˚
Fig. 4
If you use inclination angle of over 45˚, as shown in Fig. 5 move the lever (A) to inside, the saw blade may be inclined to a maximum angle of 55˚ in relation to the base.
Always ensure that the lever (A) is thoroughly tightened after making the desired adjustment.
45˚ – 55˚
Fig. 5
3.Regulating the guide (Rip fence) (Fig. 6, 7)
................................................ Optional Accessory
Install the wing bolt (B) and lock spring on the base. Insert the guide into the base, move it left and right and adjust the cutting position. Tighten the wing bolt (B) and fix the guide. The guide can be installed either from the left or the right side of the main body.
Wing bolt (B)
Lock spring
Base
Fig. 6
9