Hitachi CP-S370W user manual No Signal Menu, OPERATIONS continued, Description, ENGLISH-16

OPERATIONS (continued)

No Signal Menu

The same adjustments and settings are available as with the Image and Options menus when the MENU button is pressed during display of the “NO INPUT IS DETECTED ON ***” or “SYNC IS OUT OF RANGE ON ***” message while no signal is received.Select an item with the and buttons, and start or stop operation with the and buttons.

VOLUME

BLANK

MIRROR

START UP

MENU COLOR LANGUAGE AUTO OFF SYNC ON G WHISPER

16

Table 8. No Signal Menu

Item Description

Reduce ↔ Increase

•When this function is used, audio input is automatically switched to video. The

VOLUME	audio input can be switched by moving the DISK PAD left and right during the
	display of the volume adjustment bar. The volume adjustment bar is displayed by
	pressing VOLUME / button.
	Select Blank Screen Color: Select the color with the			/ button.
BLANK	• When the blank mode is set with BLANK ON, by absence of a signal, or by
	input of a non-standard signal, the image is cleared and the complete screen is
	displayed in the selected color.
MIRROR	Select Mirror Status: Select the mirror status with the			/	button.
	Setup Initial Screen Display: Select the TURN ON with the				button.
START UP	Clear Initial Screen Display: Select the TURN OFF with the				button.
	• Note that if TURN OFF is selected the blank screen is displayed in blue when
	there is no signal.
MENU COLOR	Select Menu Background Color: Select the color with the				/
	button.
LANGUAGE	Select Menu Display Language: Select the language with the /
	button.
	Set AUTO OFF: Set 1~99 minutes with the	/	button. The system
	automatically enters the standby mode when a signal is not received for
AUTO OFF	the set time.
	Clear AUTO OFF: Select the STOP (0 min.) with the			button. When
	the STOP is selected the system does not enter the standby mode even
	if no signal is received.
	SYNC ON G Valid: Select the TURN ON with the		button.
SYNC ON G	SYNC ON G Invalid: Select the TURN OFF with the			button.
	• May not be displayed correctly with some input signals when the SYNC ON G is
	valid. In such cases, remove the signal connector so that no signal is received,
	set the SYNC ON G to invalid, and reconnect the signal.
	Set / Crear WHISPER Mode: Press the /	button. When the
WHISPER	WHISPER is selected, the WHISPER mode is active. In the WHISPER
	mode, acoustic moise level from the unit is reduced, and brightness
	level on screen is a little lower.

ENGLISH-16