Magnify function, Moving the display area | Hitachi CP-S860E

Basic operations (continued)

Magnify function

Part of an image can be displayed magnified. This function can be used together with the FREEZE function (refer to page 10).

5

VIDEO RGB

LASER

STANDBY/ON POSITION

4

RESET

1,2

3

MENU		6
	FREEZE	6
MAGNIFY	VOLUME
	OFF
P in P	MUTE
BLANK	AUTO TIMER

1 Press the MAGNIFY + button.

• The center part of the image will be displayed magnified approximately two times.

Changing the magnification ratio

2 Press the MAGNIFY + button.

• When this button is pressed, the image will be displayed even larger.

3 Press the MAGNIFY – button.

• When this button is pressed, the image will be displayed even smaller.

Moving the display area

4	Press the POSITION button.
5	Press the DISK PAD up, down, left and right buttons.
	• The magnified area will move in accordance with the button pressed.

Returning to normal display

6 Press the MAGNIFY OFF button.

Caution • The magnify function will be cancelled when the input select button is pressed or the display mode of the PC being used for display is changed.

• Cancelled when the magnified display or menu display is on.

16

Image 16

Hitachi CP-S860E Magnify function, Changing the magnification ratio, Moving the display area, Returning to normal display

Contents

ContentsPage FeaturesOutline Page Before Use If a problem should occur Do not install on an unstable surfaceDo not look through the lens when the lamp is on Use only the indicated power supply Do not position the power Handle the power cord with careDo not allow the laser beam to enter the eyes Care and maintenance Battery usageClean the projector interior once every two years Avoid installation in humid or dusty locations Sound volume Avoid excessively hot locationsLens care Cabinet care Checking the package Contents Names and functions of each part Names and functions of each part Remote control transmitter Disk PAD 3Close the battery cover 1Remove the battery cover2Loading the batteries Installation Typical LCD Projector and Screen InstallationUsing the adjusters Top view Side view Basic operations To project Turning off the power Turn off the main power switch of the projector OFFPlug & Play Press the STANDBY/ON button for approximately 1 sec Freeze function Cancelling the Freeze functionPress the Freeze button Magnify function Changing the magnification ratioMoving the display area Returning to normal display Returning to the initial settings Adjustments and functionsPress the Menu Using the Setup Menu Input RGB Keystone Blank Timer Language Connection to the video signal terminals Connection to the RGB signal terminalInput signals Signal input jacks Connection to the RGB signal terminal Example of computer signal Connection to the RGB signal terminal Initial set signals Connecting the USB Connection to the control signal terminal Mouse functions Connection to the control signal terminal Control signal jack RS232C communication Command data chart System Video Requesting projector status Cleaning the Air filter Example of system setupPull out the power cord Remove the front air filter Cleaning the air filter with a vacuum cleaner Installing the air filterLamp Message table When you think something wrong Indicators Specifications Dimensional Diagram About the warranty About the warranty and after-serviceRepairs after the warranty period has elapsed