SETTING UP THE PROJECTOR
CAUTION • Install the projector in a suitable environment according to instructions of the accompanying manual “SAFETY INSTRUCTIONS” and this manual.
•If you press the elevator buttons without holding the projector, the projector might crash down, overturn, smash your fingers and possibly result in malfunction. To prevent damaging the projector and injuring yourself, ALWAYS HOLD THE PROJECTOR whenever using the elevator buttons to adjust the elevator feet.
•An installation angle should be adjusted within the specified adjustment range. The adjustment beyond the range may become the cause of shortening the lamp life.
Adjusting the Projector's Elevator Feet
If the surface on which the projector is placed, or the screen is tilted, use the elevator feet and elevator screw to adjust the projection angle of the main unit. The adjustment range of the elevator feet is 0 to 10 degrees.
Press and hold in the elevator
1 buttons
Elevator button 
Raise or lower the projector to the
2 desired height and then release the elevator buttons
When you release the elevator buttons, the elevator feet will lock into position.
Elevator feet
3 Turn the elevator screw to fine tune.
Elevator screw
6
