English
ASSEMBLY AND OPERATION
APPLICATIONS
Rotation and striking function
Drilling anchor holes
Drilling holes in concrete
Drilling holes in tile Rotation only function
Drilling in steel or wood
Tightening machine screws, wood screws
REMOVAL AND INSTALLATION METHOD OF BATTERY
How to install the battery.
Align the battery with the groove in tool handle and slip it into place.
Always insert it all the way until it locks in place with a little click, If not, it may accidentally fall out of the tool, causing injury to you or someone around you (Fig. 3).
How to remove the battery.
Withdraw battery from the tool handle while pressing the latch (2 pcs) of the battery (Fig. 3).
Handle
Insert
Pull out
Battery Push
Latch
Fig. 3
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the charger will burn out.
1.Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, the charge status lamp will blink in red. (At
WARNING:
Do not use the electrical cord if damaged. Have it repaired immediately.
2.Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in Fig. 4. Make sure it contacts the bottom of the battery charger.
Battery
Charge status lamp (red)
Overheat lamp (green)
Fig. 4
3.Charging
When the battery is connected to the battery charger, charging will commence and the charge status lamp will light in red. (See Table 2)
NOTE:
If the charge status lamp flikers in red, pull out the plug from the receptacle and check if the battery is properly mounted.
When the battery is fully charged, the charge status lamp will bilink in red slowly. (At
11