English
CAUTION:
◯The dust cup and dust collector (B) are for exclusive use of concrete drilling work. Do not use them for wood or metal drilling work.
◯Insert dust collector (B) completely into the chuck part of the main unit.
◯When turning the rotary hammer on while dust collector (B) is detached from a concrete surface, dust collector (B) will rotate together with the drill bit. Make sure to turn on the switch after pressing dust cup on the concrete surface. When using dust collector (B) attached to a drill bit that has more than
◯Dump particles after every two or three holes when drilling.
◯Please replace the drill bit after removing dust collector (B).
8.Selecting the driver bit
Screw heads or bits will be damaged unless a bit appropriate for the screw diameter is employed to drive in the screws.
9.Confirm the direction of bit rotation (Fig. 6)
The bit rotates clockwise (viewed from the rear side) by pushing the
|
| L | Push |
R |
| L | Button |
|
|
| |
| L | R |
|
|
|
| |
|
| R |
|
Fig. 6
HOW TO USE
CAUTION:
◯To prevent accidents, make sure to turn the switch off and disconnect the plug from the receptacle when the drill pits and other various parts are installed or removed. The power switch should also be turned off during a work break and after work.
1. Switch operation
◯The rotation speed of the drill bit can be controlled steplessly by varying the amount that the trigger switch is pulled. Speed is low when the trigger switch is pulled slightly and increases as the switch is pulled more. To turn the switch OFF, release the trigger switch to its original position.
◯Pulling the trigger and pushing the stopper, it keeps the
12
