Fig. 10
Push
button Change lever

English

2.Rotation + Hammering

This rotary hammer can be set to rotation and hammering mode by pressing the push button and turning

the change lever to mark. (Fig. 7)

(1)Mount the drill bit.

(2)Pull the trigger switch after applying the drill bit tip to the drilling position (Fig. 8)

(3)Pushing the rotary hammer forcibly is not necessary at all. Pushing slightly so that drill dust comes out gradually is just sufficient.

Change lever

Push button

Fig. 7

Fig. 8

CAUTION:

￿ When the drill bit touches an iron reinforcing rod, the bit will stop immediately and the rotary hammer will react to revolve. Therefore please grip the side handle and handle tightly as shown in Fig. 8.

3. Rotation only

This rotary hammer can be set to

 

 

 

rotation only mode by pressing the

 

 

 

push button and turning the change

 

 

 

lever to mark. (Fig. 9)

 

 

 

To drill a wood or metal material using

 

 

 

the separately sold drill chuck and chuck

 

Fig. 9

 

adaptor, proceed as follows. Installing

 

 

drill chuck and chuck adaptor (Fig. 10):

 

Front cap

Grip

(1) Attach the drill chuck to the chuck

 

 

 

 

 

 

adaptor.

 

 

 

(2) The part of the SDS-plus shank is the

 

 

 

same as the drill bit. Therefore, refer to

 

 

 

the item of “Mounting the drill bit” for

 

Part of SDS-plus

attaching it.

 

Drill chuck

shank

 

 

 

 

Chuck adaptor

CAUTION:

￿Application of force more than necessary will not only reducing drilling efficiency at all, but will deteriorate the tip edge of the drill bit and reduce the service life of the rotary hammer in addition.

13