(1) Center pin
Applied to core bits from 38 mm to 150 mm
Applied to core bits 32 mm and 35 mm
NOTE:
Do not use core bits 25 mm or 29 mm.
(2) Core bit
External dia. 25, 29, 32, 35, 38, 45, 54, 64, 79, 94, 105, 120, 150 mm
(with guide plate, not applicable to cores 25 mm or 29 mm)
(3) Core bit shank
Applied to core bits above 38 mm
Applied to core bits below 35 mm
4.Drilling holes .... For drilling metal and wooden materials
13 mm drill chuck | Chuck adapter |
(13VLA) | (SDS max shank) |
Chuck wrench
5.Bolt placing operation with Chemical Anchor (Rotation + Hammering)
(Standard socket | (SDS max shank) |
on the market) | 12.7 mm Chemical |
| Anchor Adaptor |
| 19 mm Chemical |
| Anchor Adaptor |
6.Crushing (Hammering)
(1)Bull point
Overall length: 280, 400 mm
7. Groove digging and edging (Hammering)
(1) Cold chisel
Overall length: 280, 400 mm
8.Asphalt cutting (Hammering)
(1)Cutter
9.Scooping Work (Hammering)
(1)Scoop
10. Surface Roughing (Hammering)
(1) Bushing Tool | (2) Shank |
11. Tamping (Hammering)
(1) Rammer | (2) Shank |
150 ⋅ 150 mm |
|
12. Syringe (for chip removal)
Hammer grease A 500 g (in a can)
70 g (in a green tube)
30 g (in a green tube)
Optional accessories are subject to change without notice.
APPLICATIONS
Drilling holes in concrete
Drilling anchor holes
Crushing concrete, chipping, digging, and squaring (by applying optional accessories)
PRIOR TO OPERATION
1.Power source
Ensure that the power source to be utilized conforms to the power requirements specified on the product nameplate.
2.Power switch
Ensure that the power switch is in the OFF position. If the plug is connected to a power receptacle while the power switch is in the ON position, the power tool will start operating immediately, which could cause a serious accident.
3.Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness and rated capacity. The extension cord should be kept as short as practicable.
4.How to install tool NOTE:
For tools such as a bull point and a cold chisel,
use only Hitachi genuine parts.
(1)Clean, then smear the tool shank with the grease provided in the green tube (Fig. 1).
4