English

NOTE: Loosening stuck or hard to move sleeves.

Grasp the bit installed in the keyless chuck, in a vise or similar tool.

Set the cap position to “1-7” and turn the switch on. The motor then starts. Finally, rotate the sleeve to the left, and it will loosen.

5.Automatic spindle-lock mechanism

This unit has automatic spindle-lock mechanism for quick bit changes.

6.Confirm that the battery is mounted correctly

7.Check the rotational direction

The bit rotates clockwise (viewed from the rear side) by pushing the R-side of the selector button.

The L-side of the selector button is pushed to turn the bit counterclockwise. (See Fig. 17) (The L and R marks are provided on the selector button.)

￿When the trigger switch is depressed, the tool rotates. When the trigger is released, the tool stops.

￿The rotational speed of the drill can be controlled by varying the amount that the trigger switch is pulled. Speed is low when the trigger switch is pulled slightly and increases as the trigger switch is pulled more.

￿When releasing the trigger of the switch, the brake will be applied for immediate stopping.

Trigger switch

R L

Selector button

Fig. 17

8. Change rotation speed

Shift knob

Shift knob

Low speed

High speed

Fig. 18

Fig. 19

(1)Operate the shift knob to change the rotational speed. Move the shift knob in the direction of the arrow. (See Fig. 18 and 19)

When the shift knob is set to “LOW”, the drill rotates at a low speed. When set to “HIGH”, the drill rotates at a high speed.

(2)As shown in Fig. 20, when the rotation switch-over lever is slid to the lower side, the power mode (P) is set. And when slid to the upper side, the save mode (S) is set.

Save mode (S)

Switch-over

Power lever mode (P)

Fig. 20

21