WARNING: Check the manufacturer’s maximum pressure rating for nailers, staplers and accessories. Compressor outlet pressure must be regulated so as to never exceed the maximum pressure rating of the nailers, staplers and accessories.
Pressure gauge | Knob of the pressure switch |
(B)indicates the working pressure
Pressure gauge
(A)indicates the pressure in the air
tank
Knob of the
pressure LOCK reducer
UNLOCK
Fig.4
3.Shutdown
(1)Push the knob of the pressure switch to “OFF” (Refer to Fig. 1 and Fig. 2).
(2)Unplug the plug from power source.
(3)Open the drain cock located at the lower part of the tank (Fig. 5).
English
1. Draining tank
Drain tank daily or after 4 hours of use. Open drain cock and tilt compressor to empty accumulated water (Refer to Fig. 5).
SERVICE AND REPAIRS
All quality compressors will eventually require servicing or replacement of parts because of wear from normal use. To assure that only authorized replacement parts will be used, all service and repairs must be performed by a HITACHI AUTHORIZED SERVICE CENTER, only.
NOTE: Specifications are subject to change without any obligation on the part of the HITACHI.
WARNING
Tank
Risk of bursting. When the tank gets corroded, there is a risk of breakdown. Water will condense in the air tank. If not drained, water will corrode and weaken the air tank causing a risk of air tank rupture. Drain tank daily or after 4 hours of use. The drain contains moisture in the air, abrasion particles, rust, etc. To drain tank open valve slowly and tilt compressor to empty accumulated water. Keep face and eyes away from drain cock.
Drain cock (discharge tap)
Fig.5
MAINTENANCE
WARNING: Disconnect the compressor from the power source and remove the compressed air from the air tank before performing the maintenance operations. Allow the compressor to cool before performing the maintenance operations.
9
