English
APPLICATIONS
Air source of the pneumatic nailer and stapler.
WARNING: Never use compressor for applications other than compressor for pneumatic nailer and
stapler.
CAUTION : In order to avoid damaging the compres- sor, do not allow the unit to be tilted more
than 10° when operating.
NOTE: When operating or storing the copmressor, set 4 rubber bumpers downward on the floor (Refer to Fig.1)
6.Temperature
Operating temperatures are between 32°F and 104°F (0°C and 40°C).
PRIOR TO OPERATION
1.Power source
Ensure that the power source to be utilized conforms to the power source requirements specified on the product nameplate.
2.Power switch
Ensure that the knob of the pressure switch is in the “OFF” position (Fig. 2). If the plug is connected to a receptacle while the knob is in the “ON” position, the compressor will start operating immediately and can cause serious injury.
CAUTION: Never operate in temperatures below 32°F (0°C) or above 104°F (40°C).
TRANSPORT
Push the knob of the pressure switch to “OFF” and disconnect it from the power source before move the compressor. Transport the compressor in the correct manner.
ON |
OFF |
OPERATION
1.
Insert the plug into the receptacle and start the compressor by pulling the knob of the pressure switch to “ON” (Refer to Fig. 2).
WARNING: Do not stop or start the compressor by use of the plug. Always use “ON/OFF”
knob located on the pressure switch.
The operation of the compressor is automatic and is controlled by the pressure switch which stops it when the pressure in the
Knob of the pressure switch
Fig.2
3.Extension cord
When the work area is far away from the power source, use an extension cord of sufficient thickness and rated capacity (refer page 6). The extension cord should be kept as short as practicable.
WARNING: Damaged cord must be replaced or repaired.
4.Confirm the power receptacle
If the power receptacle only loosely accepts the plug, the receptacle must be repaired. Contact the nearest electric store for repair service.
If such a faulty receptacle is used, may cause overheating, resulting in a serious hazard.
5.Right running position
Position the compressor on a flat surface or one with an inclination of 10° at the most, in a well ventilated area away from atmospheric agents and not in explosive areas.
The motor of the compressor is fitted with a thermal protection inside the wrap, which stops the compressor when the temperature is too high. Should this be tripped, the compressor will restart automatically after
CAUTION: Wear appropriate personal hearing protection during use. Under some
conditions and duration of use, noise from this product may contribute to hearing loss.
2.Adjustment of working pressure
Unlock the knob of the pressure reducer pulling it up, adjust the pressure to the required level by turning the knob clockwise to increase and counterclockwise to decrease. A pressure gauge (B) is provided to know when the required pressure is reached, lock the knob by pushing it down firmly (Refer to Fig. 3).
When adjusting the pressure, check and make sure that a pressure gauge for the tank has the pressure level that is higher than that of the pressure to be adjusted.
It is also imperative that you make adjustment by slowly starting up the pressure from the level that is lower than the pressure to be adjusted.
- 8 -
