Hitachi GD-2000 manual Hardware Installation

GD-2000 Manual 6/18/98 5:25 PM Page 10

HARDWARE OPTION

•Audio connecting cable

•Sound card

SOFTWARE

• DVD-ROM device driver

NOTE: If you need an interface card, interface cable or DVD-ROM device driver, contact your dealer.

Hardware Installation

To install this DVD-ROM drive in the host computer, refer to the instruction manual of each host computer. To install the interface card in the host computer, refer to the instruction manual of each host computer and each interface card.

Install the DVD-ROM drive following the general installation procedure shown below:

1)Check the Device Configuration Jumper Settings of the DVD-ROM drive such as Master, Slave, CSEL. (See page 9)

2)Turn off the host computer and unplug the power supply cable of the host computer.

3)Remove the host computer cover.

4)Install the DVD-ROM drive into the host computer and mount tightly with screws.

5)Check the settings of the interface card.

6)Install the interface card in the slot.

7)Firmly attach the interface cable from the interface card to the DVD-ROM drive.

8)Firmly attach audio connecting cable as required.

9)Finally, firmly attach a spare DC power supply cable from the computer power supply to the DVD-ROM drive.

10)Install the host computer cover.

GD-2000 DVD-ROM Manual - Page