English
(5)Separate the push lever from the workpiece.
Next, point the nailer downward, pull the trigger and then wait in that position for 5 seconds or longer.
THE NAILER MUST NOT OPERATE.
Pull trigger
(6)Without touching the trigger, depress the push lever against the workpiece.
Pull the trigger.
THE NAILER MUST OPERATE.
(7)If no abnormal operation is observed, you may load nails in the Nailer.
Drive nails into the workpiece that is the same type to be used in the actual application.
THE NAILER MUST OPERATE PROPERLY.
LOADING NAILS
WARNING
When loading nails into Nailer,
1)do not depress trigger;
2)do not depress push lever; and
3)keep Nailer pointed downward.
(3)Pull the nail feeder (B) back to engage the feeder knob to the nail strip.
Feeder knob
Nail feeder (B)
NOTE:
Quietly push the nail feeder (B) and feeder knob against the nail.
If the nail feeder (B) and feeder knob are released from backward the magazine and bumped against the nail, the connecting paper or plastic of the nail can be damaged.
Use nail strip of more than 10 nails.(NR90GC2)
Use an unbroken nail strip with nails of all the same length. (NR90GR2)
The Nailer is now ready to operate.
Removing the nails:
1Pull the feeder knob backward.
2Return the feeder knob forward quietly while pushing the nail feeder (B).
3Pull out nails from the back of the magazine.
1
(1) Insert nail strip into the back of the magazine.
2
Feeder knob
Magazine
(2) Slide the nail strip forward in the magazine.
Nail feeder (B)
Nails
3
— 16 —