English
MAINTENANCE
NOTE: The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer. Some illustrations in this Manual may show details or attachments that differ from those on your own Nailer.
MAINTENANCE AND INSPECTION
Read section titled “SAFETY” (pages 4 – 7).
WARNING
●Disconnect air hose and remove all nails from Nailer when:
1)doing maintenance and inspection; and
2)clearing a jam.
1.Clearing a jam
Remove a jammed nail in the following order:
1 DISCONNECT AIR HOSE.
2 Open the nail guide.
3 Insert a rod into the outlet. Tap the rod with a hammer.
Hammer
Rod
Outlet
1
6In case of frequent jam, contact a Hitachi authorized service center.
2.Inspecting the push lever
1 DISCONNECT AIR HOSE.
2 Clean the push lever sliding part.
Lubricate it with Hitachi pneumatic tool lubricant.
| 1 Disconnect |
Lubricate | air hose |
3.Inspecting the feeders
1 DISCONNECT AIR HOSE.
2 Clean the knob sliding part.
Lubricate it with Hitachi pneumatic tool lubricant.
Nail 
Guide
Disconnect air hose
Push Lever
1
Knob
4Remove the jammed nail with a slotted screw driver.
3Open the nail guide and remove dust.
Lubricate the sliding groove of the feeder and shafts.
Nail Guide
Nail | Slotted Screw Driver |
5Cut the deformed collated wire with nippers. Correct the deformation.
Main Nail Stopper |
|
Sub Nail Stopper | Nose Opening |
Feeder | Feeder Shaft |
17