English

ASSEMBLY AND OPERATION

 

APPLICATIONS

 

￿ Sanding finish and flooring finish of woodwork

Idle pulley

products.

￿ Base polishing of Lumber-coated planes.

 

￿ Sandfng finishes of metal surfaces.

 

￿ Base polishing of metal-coated planes, rust

 

removal, or paint removal paint to refinishing.

 

￿ Surfacial finish of slate, concrete, and so on.

 

PRIOR TO OPERATION

1.Power source

Ensure that the power source to be utilized conforms to the power source requirements specified on the product nameplate.

2.Power switch

Ensure that the switch is in the OFF position. If the plug is connected to a receptacle while the switch is in the ON position, the power tool will start operating immediately and can cause serious injury.

3.Extension cord

When the work area is far away from the power source, use an extension cord of sufficient thickness and rated capacity. The extension cord should be kept as short as practicable.

WARNING:

Damaged cord must be replaced or repaired.

4.Check the receptacle

If the receptacle only loosely accepts the plug, the receptacle must be repaired. Contact a licensed electrician to make appropriate repairs.

If such a fautly receptacle is used, it may cause overheating, resulting in a serious hazard.

5.Confirming condition of the environment: Confirm that the work site is placed under appropriate conditions conforming to prescribed precautions.

HOW TO HANDLE SANDING BELT

WARNING:

Be sure to switch power OFF and disconnect the plug from the receptacle to avoid serious trouble.

1.How to attach sanding belt

(1)Pull lever with finger, idle pulley will then move backward.

Lever

Fig. 2

(2)Place on drive pulley and idle pulley passing it over the outside of shoe plate and making sure that arrow on inside of belt coincides with rotational direction of drive pulley.

Drive pulley

 

Rotational

Idle

direction

pulley

 

Shoe plate

Sanding belt

Fig. 3

(3)Push lever with finger, idle pulley will then move forward and give proper tension to sanding belt. In this case, be careful not to be hit your finger by lever.

Then, adjust sanding belt position. (refer to page 8)

CAUTION:

Sanding belt installed in the wrong direction will lower work efficiency and shorten life of sanding belt.

2.How to remove sanding belt

Pull lever with finger, sanding belt will then sag and can be taken off pulleys eqsily.

DUST REMOVAL

When an excessive amount of dust is deposited in the dust bag, dust-collecting efficiency will sharply drop. Remove dust from the bag when it is deposited up to about 2/3 the bag capacity, where by dust collecting efficiency (as well as working efficiency) will be ensured.

7