Advanced Techniques

PHILIPS

 

RCA

DISPLAY

Zenith

COUNTER RESET

Magnavox

TITLE ON/OFF

Note: The remote control code is held in memory until it is changed or the batteries are replaced.

Note: Point the remote control straight at the VCR's infrared receiver for operation.

Note: Use the remote control indoors. When the infrared receivers of the VCR and camcorder are exposed to direct sunlight or strong artificial light, the remote control may not operate correctly.

Note: The remote control cannot be operated if there is an obstacle between the remote control and infrared receiver. Especially, be careful of this during dubbing.

Note: When the edit remote control is connected to the camcorder, the buttons marked * in the figure above perform the same operations as those of the other remote control provided.

Operation

You can select up to four different scenes or segments to be copied at one time.

Note: If sunlight or strong artificial light strikes the camcorder's infrared receiver, the editing operation may not be possible.

Programmable Edit Hookup

1.Use the audio/video output cable to connect the camcorder and VCR as illustrated and then connect the edit remote control to the camcorder.

Note: If your VCR has two (stereo) AUDIO IN jacks, connect the audio plug to the left- channel AUDIO IN jack.

2.Insert a recorded tape into the camcorder.

3.Set the CAM/OFF/VIDEO switch of the camcorder to VIDEO. Turn the recording VCR on and select line input.

4.Press the PROGRAM button of the remote control. The program display appears in the viewfinder.

Note: If your VCR is connected to a TV, the program display will also appear on the TV screen.

5.Press the button and use the or button to search for the starting point of the segment you want to copy. Press and then to set the camcorder to the play pause mode.

The linear time counter counts when searching for the starting point.

Use the FORWARD and REVERSE buttons in the play or pause mode to fine adjust the