ATTACHING THE OPTIONAL DC CAMERA LIGHT (VM-CP4)

NOTES:

•Never touch the terminal of the DC camera light with your hand or short it using metal.

•When the camera light is on, do not allow water to drop on the light.

•When the camera light is on, avoid subjecting the camera light to impacts or sharp vibrations.

•Do not allow the cooling vents to become blocked. Also, do not cover the camera light with paper or other objects, since the air flow will be interrupted, resulting in possible overheating hazard.

•Never use the camera light in the vicinity of explosive or highly inflammable materials.

•When storing the camera light in the camera case following use, be sure to allow it sufficient time to fully cool down before placing it in the case.

•Replace only with VM-CP4L lamp (optional accessory), to reduce the risk of fire.

To replace the lamp of the camera light

￿Turn the front case in the direction of the arrow to remove it.

￿Remove the lamp in the direction of the arrow. Install a new lamp into the camera light securely by aligning the recess of the lamp and the "" mark of the light.

￿Press the lamp through the hole of the reflective place and re-attach the front case to the camera light by aligning the "-" marks of the front case and camera light, then turn the case in the direction of the arrow.

NOTES:

•Do not touch the lamp directly with your fingers. It may shorten its service life.

•When the lamp is replaced, or when the front case of the camera light is removed, make sure the front case is attached to the camera light properly.

76