Advanced Techniques
Note: Point the remote control straight at the VCR's infrared receiver for operation.
Note: Use the remote control indoors. When the infrared receivers of the VCR and camera/recorder are exposed to direct sunlight or strong artificial light, the remote control may not operate correctly.
Note: The remote control cannot be operated if there is an obstacle between the remote control and infrared receiver. Especially, be careful of this during dubbing.
Note: When the edit remote control is connected to the camera/recorder, the buttons marked * in the figure above perform the same operations as those of the other remote control provided.
Operation
You can select up to four different scenes or segments to be copied at one time.
Note: If sunlight or strong artificial light strikes the camera/recorder's infrared receiver, the editing operation may not be possible. In this case, attach the microphone cap to cover the receiver, then try to operate the edit remote control again.
Programmable Edit Hookup Illustration
1.Use the AV stereo output cable to connect the camera/recorder and VCR as illustrated and then connect the edit remote control to the camera/recorder.
2.Insert a recorded tape into the camera/recorder.
3.Set the CAM/OFF/VIDEO switch of the camera/recorder to VIDEO. Turn the recording VCR on and select line input.
4.Press the PROGRAM button of the remote control. The program display appears in the viewfinder.
Note: If your VCR is connected to a TV, the program display will also appear on the TV screen.
5.Press the 
button and use the 
or 
button to search for the starting point of the segment you want to copy. Press 
and then 
to set the camera/recorder to the play pause mode.
Use the FORWARD and REVERSE buttons in the play or pause mode to fine adjust the tape position. Press FORWARD and hold it; the tape is played while the button is held. Press REVERSE and hold it for reverse play.
6.Press the IN button to store the counter reading. When you press the IN button, OUT flashes in the program display.
7.Press the 
button to search for the end of the segment you want to copy. Press 
and then 
to set the camera/recorder to the play pause mode. Use the FORWARD or REVERSE button as required to fine adjust the tape position.
8.Press the OUT button to store the counter reading at the end of the scene.
52